Perle C/CM 10GRT-SFP Media Converter Module Installation Guide 14
Installing or Replacing Media
Converter Modules
Caution:
Observe electrostatic discharge
precautions when installing the Media Converter
Module(s) into the Chassis. Failure to observe this
caution could result in damage to the Media
Converter Module(s) and /or chassis.
The Perle Media Converter Modules can be
installed in any available slot and in any order
within the chassis.
1.
Remove the media converter module from its packaging.
2.
Using a cross-head screwdriver, remove the screw
holding the face plate to the chassis to reveal the slot
opening.
3.
Set the jumpers and DIP switches on the media converter
module to the desired operating mode.
4.
Locate the top and bottom alignment guides inside the
chassis.
5.
Using the module alignment guides gently slide the
module into the slot until it becomes flush with the front
of the chassis. Light pressure may be needed to seat the
module. Do not force the module as you might cause
some damage. If there is resistance, remove the module,
check the module connector for damaged or incorrectly
aligned pins, if there is no damage, retry to insert the
module.
6.
Tighten the captive retainer screw to ensure the media
converter module is locked in place.
7.
Remove the dust cap from the fiber connector and
connect the fiber and copper cables.
