Fast Ethernet Fiber to Fiber Media Module – Installation Guide
2
Overview
This document contains instructions necessary for the installation
and operation of the Perle Fast Ethernet Fiber to Fiber Media
Converter Module(s) (C-100MM and CM-100MM) that are used in
conjunction with a Perle MCR chassis. The C-100MM are the
unmanaged media converter modules, and the CM-100MM are
the managed versions. These products allow dissimilar 100Base-X
fiber interfaces to connect to each other.
These are the fiber to fiber conversion models:
•
Multimode to Multimode (MM)
•
Multimode to Single Mode (SM)
•
Multimode to Single Mode Single Strand (SM)
These media converter modules operate over different
wavelengths and distances, depending on the model selected
(See tables below). For information on the management options of
the CM-100MM converter module, refer to the MCR-MGT Module
User’s Guide.
Fiber port 1 – MM1
Model
Connector
Mode
Distance
Wavelength
(TX/RX)
All models
SC/ST/LC
MM.
2 km/1.2 mi.
1310 nm
Fiber port 2 – MM2/SM2
Model
Connector
Mode
Distance
Wavelength
(TX/RX)
C-100MM-M2xx2
CM-100MM-M2xx2
SC/ST/LC
MM
2 km/1.2 mi.
1310 nm
C-100MM-S2xx20
CM-100MM-S2xx20
SC/ST/LC
SM
20 km/12.4 mi
1310 nm
C-100MM-S2xx40
CM-100MM-S2xx40
SC/ST/LC
SM
40 km/24.9 mi
1310 nm
C-100MM-S2xx80
CM-100MM-S2xx80
SC/ST/LC
SM
80 km/49.7 mi
1550 nm
C-100MM-S2xx120
CM-100MM-S2xx120
SC/ST/LC
SM
120 km/74.6mi
1550 nm
C-100MM-S1SC20U
CM-100MM-S1SC20U
SC
SM
20 km/12.4 mi.
1310/1550 nm
