Perle 10/100/1000 Media Converter Module – Installation Guide
9
Speed copper (Switch 5)
Switch Position
Mode
Up (default)
100
Down
10
Note When Auto Negotiation (SW1) is set to Off, the Media
Converter Module will use this switch setting for its Ethernet
copper speed setting.
Up: The Media Converter will be fixed at 100 Mbps.
Down: The Media Converter will be fixed at 10 Mbps.
Fiber Negotiation (Switch 6)
Switch Position
Mode
Up (default)
Auto
Down
Off
Up: The Media Converter will negotiate Ethernet parameters on
the fiber connection. This will ensure that the most optimal
connection parameters will be in effect. If connecting to another
Perle Media Converter, this parameter should be set to Auto. The
Media Converter Module will advertise 1000Mbps, Full and Half
Duplex, no Pause.
Down: The Media Converter Module’s fiber will be fixed to
1000Mbps, Full Duplex.
When using a 100 Mbit SFP module
Full/Half Duplex on Fiber (Switch 6)
Switch Position
Mode
Up (default)
Full
Down
Half
Up: The Media Converter Module will be set to Full Duplex mode
on its fiber link.
Down: The Media Converter Module will be set to Half Duplex
mode on its fiber link.
