Perle MCR200 Guide
4
Installing or Removing Modules:
Caution: Observe electrostatic discharge precautions when
installing or removing the Module(s) from the Chassis.
Failure to observe this caution could result in damage to the
Module(s) and/or chassis.
Installing:
1.
If installing or replacing a Media Converter Module,
remove the Module from its packaging.
2.
Using a cross-head screwdriver, remove the screw
holding the face plate (if installed), on the chassis, to
reveal the slot opening.
3.
Set the Module’s DIP switches to the desired operating
mode (refer to the Installation Guide that came with the
Media Converter Module).
4.
Locate the alignment guides inside the slot.
5.
Using the alignment guides gently slide the module into
the slot until it becomes flush with the front of the
chassis. Light pressure may be needed to seat it
properly, however not force the module as this may
cause damage to the connector pins. If there is
resistance, remove the module and check both
connectors for any damage, before re-attempting.
6.
Tighten the Captive retainer screw to ensure the module
is locked in place.
Note: An open slot in the chassis should be covered
with the supplied face plate (available as an accessory).
Removing:
