56
To verify that PPPoE is enabled for this remote connection, view the
read-only parameter
Location:
Main
ª
Configuration
ª
WAN Set-UP
ª
Remote Site Set-Up
ª
Edit Remote Site
ª
Protocol Set-Up
ª
PPPoE
ª
enabled
When setting up your PPPoE link with your ISP provider, one global
IP addresses will be provided that should be used for the PPPoE
remote site configuration. By enabled the NAT feature on the remote
site configuration allows you to maintain only one global IP addresses
for all PC workstation on your internal LAN.
Location:
Main
ª
Configuration
ª
WAN Set-up
ª
Remote Site Set-Up
ª
Edit Remote Site
ª
Protocol Set-Up
ª
IP Set-up
ª
NAT enabled
ª
enabled
Access to some web pages is a common problem experienced when
running a PPPoE client on a router. By design, PPPoE packets can
support a maximum MTU of up 1492 bytes. Normally when a
connection is established over common PPP, the TCP protocol
negotiates its maximum data size using the mss option (default 1460).
By default, most Windows PCs have their TCP mss option set to 1460
bytes. Since PPPoE requires an additional 8 bytes of header data, the
Summary of Contents for PERLE P850
