2-3
Unit Description
2.3. Additional Button Functions
The Default and Reset buttons on the RPS front panel can be used to perform the functions
described below:
Notes:
• All Front Panel Button functions can also be disabled via the System Parameters
menu, as described in Section 5.3.
• When the RPS is reset to factory defaults, all user-defined configuration
parameters will be cleared, and the default “super” user account will also be
restored.
1.
Reboot Operating System:
a) Press and hold the Reset button for five seconds, and then release it.
b) The RPS will reboot it's operating system; all plugs will be left in their current On/Off
state.
2.
Set Parameters to Factory Defaults:
a) Simultaneously press both the Default button and the Reset button, hold them for five
seconds, and then release them.
b) All RPS parameters will be reset to their original factory default settings, and the unit
will then reboot. All plugs will be left in their current On/Off state.
3.
Toggle/Default All Plugs:
a) Press the Default button, hold it for five seconds, and then release the Default Button.
b) The RPS will switch all plugs to the Off state. If all plugs are already in the Off state,
then the unit will reset all plugs to their user defined default states.