5-12
Basic Configuration
•
Callback Attempts:
The number of times that the RPS will attempt to contact the
Callback number. (Default = 3 attempts.)
•
Callback Delay:
The amount of time that the RPS will wait between Callback attempts.
(Default = 30 seconds.)
Notes:
• After configuring and enabling Callback Security, you must then define a callback
phone number for each desired user account (as described in Section 5.5) in
order for this feature to function properly.
• When using the "On - Callback (With Password Prompt)" option, it is important
to remember that accounts that do not include a callback number will be allowed
to access command mode without callback verification.
5.3.5. Scripting Options
The Scripting Options submenu provides access to parameters that are used to set up the RPS unit
for running various scripts.
Notes:
• To access Scripting Options parameters via the Text Interface, first type
/F
and
press
[Enter]
to display the System Parameters Menu, then key in the number for
the Scripting Options item and press
[Enter]
.
• To access the Scripting Options parameters via the Web Browser Interface, place
the cursor over the "General Parameters" link, wait for the flyout menu to appear,
then click on the "Scripting Options" link.
The Scripting Options menu allows the following parameters to be defined:
•
Command Confirmation:
Enables/Disables the Command Confirmation feature. When
enabled, a "Sure" prompt will be displayed before power switching and reboot commands
are executed. When disabled, commands will be executed without further prompting.
(Default = On.)
•
Automated Mode:
When enabled, the RPS will execute switching and reboot commands
without displaying a confirmation prompt, status screen or confirmation messages. For
more information, please refer to Section 5.3.5.1 or Section 7.3. (Default = Off.)
Notes:
• When Automated Mode is enabled, security functions are suppressed, and users
are able to access configuration menus and control plugs without entering
a password. If security is a concern and Automated Mode is required, it is
recommended to use the IP Security feature (Section 5.9.3) to restrict access.
• RPS Password features will not function unless at least one user account has been
defined, and the RPS Mode feature is disabled (See Section 5.3.5.)