7-5
Operation
7.2.2. Applying Commands to Several Plugs - Text Interface
As described below, switching and reboot commands can be applied to only one Switched AC
Outlet, or to an assortment of outlets.
Note:
When switching and reboot operations are initiated, Boot/Sequence Delay
times will be applied as described in Section 5.7.
1.
Switch Several Plugs:
To apply a command to several plugs, enter the numbers of the
desired plugs, separated by commas or plus signs. For example to switch plugs A1, A3,
and A4 Off, enter either of the following commands:
/OFF A1+A3+A4
[Enter]
or
/OFF A1,A3,A4
[Enter]
Note:
In order for the "
+
" or "
,
" operators to function, there cannot be any blank
spaces between the plug name or number and the plus sign or comma.
2.
Switch a Series of Plugs:
To apply a command to a series of plugs, enter the numbers for
the plugs that mark the beginning and end of the series, separated by a colon. For example
to switch On plugs A1 through A4 enter the following:
/ON A1:A4
[Enter]
4.
All Plugs:
To apply a command to all plugs, enter an asterisk in place of the name or
number. For example, to Boot all plugs, enter the following:
/BO *
[Enter]
Note:
When this command is invoked by a User level account, it will only be applied
to the plugs that are specifically allowed for that account.
