WARNING:
Use a stud finder to locate
wood stud and mark the edge
and center location.
Position the wall plate [A] at your desired height and line up
the holes with your stud center line. Level the wall plate and
mark 2 holes.
2
1b. MOUNT WALL PLATE ON CONCRETE BLOCK OR SOLICK BRICK
Drill pilot holes using a 1/8 in (3.2 mm)
diameter drill bit.
Secure the wall plate [A] with the lag
screws [W-A-1] and washers [W-A-2].
3
4
1/8 in
Ø3.2 mm
2.0
in (50mm
)
3
UP
UP
UP
A
Level
UP
W-A-2
W-A-1
●Avoid potential personal injury or property damage! DO NOT over-tighten the
lag screws [W-A-1]. Tighten the lag screws [W-A-1] only until the washers
[W-A-2] are pulled firmly against the wall plate [A].
●Ensure the wall plate is securely fastened to the wall before continuing to the
next step.
● Any material covering the wall must not exceed 5/8 in (16 mm)
.
● Mount the wall plate [A] directly onto the concrete surface
.
● Minimum solid concrete thickness: 203 mm (8 in)
.
● Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in)
.
● Never drill into the mortar between blocks
.
● CAUTION: Secure the glass shelf to the lower glass shelf support at first, then
secure the topper-shelf.
A
