Use a stud finder(not
included) to locate wood
studs. Mark the edge and
center locations.
2A-1
2A-2
2A-3
UP
Position the wall plate template[08] at
your desired height and line up the
holes with your stud center line. Level
the template and mark the holes.
Drill 4 pilot holes using a 5 mm
diameter drill bit. Make sure
the depth is not less than
60mm.
Install the arm assembly/wall
plate using lag bolts [A1] and
washer [A2]. Tighten the lag
bolts [A1] only until the washers
[A2] are pulled firmly against the
wall plate
13mm
Socket Wrench
(Not included)
08
ø5mm
60mm
2A-4
A1 A2
Ensure alignment
using the bubble level.
Summary of Contents for PSLFK5
Page 11: ...Step 10 Manage Cables ...
