Option D
06
03
For cable interference or inset holes, use
spacers [03] to create extra space between the
TV and faceplate
●Avoid potential personal injury or property damage! DO NOT over-tighten the lag
screws [A1]. Tighten the lag screws [A1] only until they are pulled firmly against the arm
assembly/wall plate [01B].
●
DONOT USE ANCHOR [A2] FOR THIS STEP!
●Ensure the arm assembly/wall plate [01B] is securely fastened
to the wall before continuing on to the next step.
● Any material covering the wall must not exceed 5/8 in. (16 mm)
● Nominal wood stud size: common 2 x 4 in. (51 x 102 mm)
minimum 1½ x 3½ in. (38 x 89 mm)
● Stud center must be verified
WARNING:
Step 4A
Wood Stud Option
X
Step 4
For wood stud installation, follow STEP 4A
For concrete installation, follow STEP 4B
Attach the Arm Assembly/Wall Plate [01B] to Wall
4A-1
4A-2
Use a stud finder (not included)
to locate wood studs or use an
awl (not included) to verify the
edges. Mark the edge and
center locations.
Awl
(Not lncluded)
Position the arm assembly/wall plate
[01B] at your desired height and line
up the holes with your stud center
line. Level the arm assembly/wall
plate [01B] and mark the holes.
06
S1 S3 S4
S5
