Important
When.an.indicated.function.does.not.occur,.correc-
tions.MUST.be.made.before.proceeding..No.steps.
in.a.procedure.should.be.ignored.or.omitted.
before Starting The glasswasher
ChECk TO dETERMINE IF...
■
Water.and.Power.are.ON.to.glasswasher.
■
C
hemical.System.Power.Switch.is.ON.
■
Chemicals.(detergent,.sanitizer,.and.rinse.
aid).have.been.purchased.and.are.on.site.
for.use.
■
Chemical.line.drop.tubes.are.in.appropriate.
containers:
■
REd
.line.into.the.detergent.container.
■
whITE
.line.into.the.sanitizer.container.
■
bLUE
.line.into.the.rinse.additive.
.
.
....container..
REMOVE...
■
All.protective.paper.from.the.front.of.
machine.
■
Shipping.block.from.under.the.lower.spray.
arm.
INSTALL...
■
Both.glass.racks.onto.the.divider.
Starting The glasswasher
PLACE...
■
Power/drain.(on-off.drain).switch.to.ON.
ChECk...
■
Water.level.inside.the.tank.(Level.should.be.
at.top.of.overflow.tube.)
Priming The Chemical System
The.chemical.system.prime.buttons.are.located.
in.the.chemical.control.panel..Each.of.the.three.
chemical.systems.must.be.primed.separately.
■
Press.the.prime.button.until.the.chemical.is.
observed.in.the.flow.indicator.window.
■
Continue.to.press.the.prime.button.for.an.
additional.15.seconds.to.complete.the..
priming.
■
Repeat.procedure.until.all.three.systems.
have.been.primed.
Operational Testing
PRESS
■
Wash.switch.to.run.the.glasswasher.
through.a.complete.cycle.
ChECk
■
That.only.the.power.and.washing.lights.are.
illuminated.while.the.machine.is.washing.
■
.That.only.the.power.and.cycle.complete.
lights.are.illuminated.when.cycle.is.fin-
ished.
■
That.the.cycle.complete.light.goes.out.
when.divider.is.rotated.
5
Perlick.is.committed.to.continuous.improvement..Therefore,.we.reserve.the.right.to.change.specifications.without.prior.notice.
START.UP.PROCEDURES
