Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
reproduction or disclosure of this material.
Page 57
September/08
MAINTENANCE (continued)
i.
Blow dry engine and machine.
j.
Spray WD-40 or equivalent on carburetor, linkage, front of engine, and all other
moving parts except pulleys and belts.
3. Maintenance if the machine will be left inactive for longer than a week.
When you perform
this maintenance, date the maintenance log, initial the log, and check off each procedure.
Pay particular attention to the following items:
a. Make copies of the Scheduled Maintenance Log to be used for this machine.
Record completion of each maintenance item. Keep the copy with your
Operators Manual.
b. Remove fertilizer from hopper.
c. Drain and flush the tanks and spray system.
d. Remove hood covers.
e. Using low-pressure water, wash the unit. Be sure to wash under the engine and
around the engine base. (Where 4 bolts hold the engine to the frame).
f. Also wash the transaxle top & bottom, making sure to get between the wheels
and frame.
g. Check for loose fasteners and worn parts. Replace if needed.
h. Drain or empty gas or add a good fuel stabilizer.
i. Grease wheel bearings, articulating rod end, pillow block, and transaxle (2)
underside front of transaxle.
j. Spray a light coating of WD-40 over the carburetor, and it’s springs. Also any
moving parts except pulleys and belts.
k. Perform Safety Systems Check (refer to Section 3).
4. Scheduled maintenance to be performed after the first 25 hours of operation. When you
perform this maintenance, date the maintenance log, initial the log, and check off each
procedure. Pay particular attention to the following items:
a.
Make copies of the Scheduled Maintenance Log to be used for this machine.
Record completion of each maintenance item. Keep the copy with your Operators
Manual.
