© 2004 Perma Green Supreme, Inc. All rights reserved.
DOCUMENT ID: U005M
Replace Pump
1 Loosen hose clamps and disconnect hoses from pump
2 Unplug electrical connector from pump
3 Unscrew the (4) 10-24 nuts from the pump using 3/8” nut driver
4 Remove pump
5 Remove pump wiring harness including pump switch and replace with new harness
6 Put on new pump assembly on leg bolts
7 Tighten the (4) 10-24 nuts
8 Plug wiring harness together
9 Reconnect hoses
10 Re-run wiring harness and connect
TOOLS
3/8” nut driver
Pliers
1 Unscrew 10 PSI pressure cap (A)
2 Clean or replace (if needed) the rubber diaphragm
3 Rinse cap/diaphragm under running water
4 Replace cap (hand tighten only)
Clean Pressure Unloader Valve
TOOLS
none
page
3
