PERMASTEEL PG-50506SRL-SC-1, User Manual

11

ONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED 

WITH THIS GRILL. REPLACEMENT PRESSURE REGULATORS AND 

HOSE ASSEMBLIES MUST BE THOSE SUPPLIED BY THE 

MANUFACTURER

This is a LP (Liquefied Petroleum Gas) configured grill. Do not attempt to use a natural 
gas supply unless the grill has been reconfigured for natural gas use.

The installation of this appliance must conform with local codes or, in the absence of 
local codes, with either the National Fuel Gas Code, ANSI Z223. 1, or CAN/CGA-
B149.2 Propane Installation Code.

ƒ

LP TANK REQUIREMENTS – THE LP TANK USED WITH YOUR GRILL MUST 

MEET THE FOLLOWING 

1) Measurement: 12’’(30.5cm) (Diameter) X 18’’ (45.7cm) (Tall) .
2) Maximum Capacity: 20lbs(9Kg).
3) Constructed and marked in accordance with the specification for LP-gas    

cylinders of the U.S. Department of Transportation (DOT) or the National  
Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes for the    
Transportation of Dangerous Goods. See LP tank collar for marking.

4) Is arranged for vapor withdrawal.
5) Includes a collar to protect the tank valve. 
6) Has no dents or rust. A dented or rusty LP tank may be hazardous,and 

should be checked by your supplier.

7) Provides a shut-ff valve terminating in an LP gas tank valve outlet specified, as      

applicable for connection type QCC1 in the standard for compressed gas tank    
valve outlet and inlet connection ANSI/CGA-V-1.

ƒ

LP TANK VALVE USED MUST MEET THE FOLLOWING 

1) Have type I outlet compatible with regulator provided.
2) Have safety relief valve.
3) UL listed Overfill Protection Device (OPD), This OPD safety feature is 

identified by a unique triangular hand wheel. Only use tanks equipped with this    
type of valve. (As the figure shown on the next page)

ƒ

FOR YOUR SAFETY

Ensure that the black plastic grommets of the regulator provided are in place and  
that the hose does not come into contact with the heat shield or the grill head.

GAS CONNECTION