YH414561/YH414562/YH414563/YH414564 Learning Universal Remote Control
4
5.The LED goes out if the code has been accepted by the remote control. If the LED
flashes twice, that means the code may be wrong, and the remote control remains in
set-up mode, you should enter the correct code from the list again in time.
6.Check the function of the keys on remote control. If most keys on your new remote
control do not function correctly, try another 3-digit device code (e.g. 013…) from
the list under the same brand. Repeat steps 3 to 6 until all the basic functions operate
correctly. Once you satisfy the code, that means you have already got correct set up for
the device.
Remark: 1.To leave set up mode, press the device key (e.g. Projector). Or if you do not
actuate any keys within 10 seconds it will be automatically terminated.
2.You may have set up more than one device on the new remote control.
Before you operate your new remote control, please press the requested
device key first (e.g. Projector), so the remote control is surely at the proper
device status, otherwise it may control the wrong device which is not you’re
requested.
B. Set up by Learning
The LEARN function is used to supplement the preprogrammed codes. The standard
code list may provide most of functions needed, but you can add a small number of
additional functions on it. Or you can add a new code from a original remote control
which is shortage in the code list.
In learn mode, you must prepare a another original remote control where you will take
codes from.
Please use fresh batteries for both the Learning Remote Control and the Original
Remote Control.
1.Press down and hold the Learn key and press the device that you want to learn(e.g.
DVD), then release the both pressed keys. The POWER button on your new remote
control blinks and then the remote control is in learning mode for DVD codes.
2. Press and release the target button that you want to learn to (e.g.POWER), the device
button lights up.
3. Point the original remote control to the receiver LED(as the same as it’s transmitter
LED) on your new remote control, both remotes facing each other by approximately
30mm apart.
4
.
Press and hold the source button on your original remote control (e.g.POWER) until
the LED on your new remote control blinks 2 times and lights up 2 seconds, then
blinks again. (That means you have learnt POWER signal from the original remote,and
you new remote control is in learning again for next learning.)
If there is a learning problem, the light blinks 4 times and lights up for 2 seconds
then blinks, (That means you failed to learn POWER signal from the original remote,
and you new remote control is in learning again for next learning.)
5.Repeat Steps 2 to 4 to learn more buttons.
Remote Control Receiver Original Remote Control
ä
Z
Z
Target Key Source Key
