6
Problem and LED color
Description
Unit temperature is too high
Yellow and white blinking
alternately
Too high temperature of the unit (electronic board) was
detected. It will not function again until it cools down, after
which it will return to normal operation.
Battery with too low voltage is
connected
Yellow and teal blinking alternately
Battery with a voltage below 7V is connected. Change the
battery to one with voltage between 7V and 17V.
Battery with too high voltage is
connected
Red and teal blinking alternately
Battery with a voltage over 17V is connected. The battery
must be immediately disconnected, as it can cause permanent
damage!
Change the battery to one with voltage between 7V
and 17V.
Main transistor or driver damage
Red and yellow blinking alternately
Main transistor or driver is damaged. Unit needs to be sent
back for repair.
Battery voltage sensing
malfunction
Red and white blinking alternately
Battery detection system is malfunctioning. Unit needs to be
sent back for repair.
Other known problems:
Problem
Cause
Solution
Replica fires a
2-round burst in
semi-auto
mode.
Motor and battery are too strong for the
main spring, which causes overspin.
Enable AB or precocking.
Too high precocking level.
Set precocking to a lower level.
Trigger mechanism malfunction.
Check the cut-off lever and contacts,
replace if needed.
Replica does
not shoot; the
unit does not
emit any light
or sound.
Incompatible T-Deans battery connector.
T-deans plugs and sockets from
various manufacturers may
sometimes not work together
reliably. Although the plug may seem
to fit the socket nicely, the
conductive surfaces may not contact
each other, cutting the power off. In
that case try with another battery,
most preferably with T-deans socket
made by different manufacturer.
Battery and/or
the motor heat
up very much.
The battery has a too low capacity (mAh)
and/or “C” parameter.
Use a battery with higher capacity
and/or “C” parameter.
The motor is too weak.
Use a stronger motor, possibly with
neodymium magnets.
Increased motor load caused by excessive
friction, for example caused by:
- improper shimming,
- motor positioned askew in the pistol
grip.
Remove the cause of the friction.
Attention!