4
Function and
LED color
Description
ROF reduction
White
This function allows to lower the rate of automatic fire. 5 reduction levels are
available:
1
–
6% ROF reduction
2
–
12% ROF reduction
3
–
18% ROF reduction
4
–
24% ROF reduction
5
–
30% ROF reduction
Attention!
Those are approximate values and may vary depending on replica
configuration.
No sound signal while LED glows white means, that the ROF reduction is disabled. 1
to 5 signals indicate reduction levels from 1 (the smallest) to 5 (the greatest).
Attention!
Semi-automatic shots and the first shot in burst are always fired without
any power reduction to retain good trigger response.
DMR mode
Purple
DMR Mode allows only semiautomatic shots and limits their frequency. Its main use
is for high power, DMR-styled replicas on fields, which demand such limitations. 0.25s,
0.5s, 1s, 2s and 3s intervals are available.
No sound signal while LED glows purple means, that the DMR mode is disabled. 1 to
5 signals indicate interval levels from 1 (the shortest) to 5 (the longest).
Li-Po and Li-
Ion alarm
Teal
Li-Po and Li-Ion alarm informs the user that battery voltage has fallen below 3.7V per
cell, at which the battery should not be further used and must be recharged. The unit
automatically detects the number of cells in the battery and determines a safe voltage
range.
The need for battery replacement is signaled by short sound signals every one minute.
Disable this function if you are using batteries other than Li-Po or Li-Ion.
No sound signal while LED glows white means, that the alarm is disabled. 1 signal
indicates activation of the alarm.
Master reset
Red
Master reset returns the unit to the factory settings.
To reset, pull and hold the trigger for 2 seconds. A long sound signal confirms return
to factory settings.
3.
Factory settings
New units and units, where master reset was activated, will have modes set in a following way:
•
Firing mode
–
semi on “SEMI” and auto on “AUTO”
•
AB
–
level 3
•
Precocking
–
disabled
•
Binary trigger - disabled
•
ROF reduction
–
disabled
•
DMR Mode
–
disabled
•
Li-Po and Li-Ion alarm
–
enabled
