background image

How to repair small punctures 

Warranty Registration Card

Check that the tube is fully defl ated and lies fl at.
1. Prepare a round patch no less than 3 inches or 7 centimeters in diameter.
2. Clean the patch and the area surrounding the leak with Alcoholic solution.
3. To contain excess glue, use masking tape to tape off the area around the patch.
4. Apply 3 thin, even coats of repair kit adhesive to both the surface of the P235-HF and the patch. 
    Wait 5 minutes between each coat.
5. After the 3rd coat, wait 10-15 minutes before applying the patch. Use a hand roller to apply the patch evenly. 
6. Wait 24 hours before re-infl ating. 

1. General

Please fi ll out and mail us in the enclosed Warranty Registration Card. You will void your warranty by not fi ling the regis-
tration card with us. Be sure to enter the Serial #(HIN code = the 12 digit number) you will fi nd on the inner side of the 
rear tube or capacity plate.

2. Care and Preservation

There is very little that you have to do to keep your boat in good condition for many years. You may store it infl ated or 
defl ated. If you leave it outside, raise it up off the ground. If it is going to be in left outside, cover it with a tarp (we do not 
recommend hanging the boat). If you leave it in the water, you will probably have to drain out rainwater at times. If you 
store it inside, we suggest you a cool and dry place, making sure the boat is clean and dry before you pack it up - or mold 
can accumulate. That is all you need to keep your boat in mint condition for years to come. Most dirt can be removed 
with a garden hose, a sponge and mild soap. Do not sprinkle with powders. Do not store in an area where it is likely to 
be exposed to extreme temperatures (above 60°C or below -20°C).

6

•  Perform all of your repairs in a well-ventilated area.
•  Avoid inhaling glue vapors.
•  Avoid contact with the skin or the eyes.
•  Keep all repair materials away from the reach of children. 
•  The repairs on the welds must not be glued. Only the manufacturer can perform repairs on the welds
    themselves.

Reviews: