Peter Lynn LEI series, User Manual

WarninG! 

•  The secondary safety system does not function if the primary safety on the 

depower loop is not pulled first. 

•  The secondary safety should only be pulled in case the primary safety was 

somehow not sufficient to completely depower the kite. Pull this safety only 
if there is no other way, as it will completely disconnect you from your kite. 
A loose kite might result in dangerous situations for bystanders or other kite 
flyers and may also result in permanent loss of the kite.  

•  When your kite is on the water, always be very careful with flying lines which 

are not tensioned. Make sure they do not get tangled behind any part of your 
body, harness or board.

•  After using your safety system, putting tension on any of the other lines can 

cause your kite to take off and start to pull.

Activating the secondary quick release

Re-connecting the secondary quick release

To activate your secondary quick release, move the red release cuff away from 
the large stainless steel ring.

Re-connect the secondary safety release by placing the pin through the ring, 
folding the pin back up and sliding the red release cuff over the pin. 
Make sure the release cuff is sitting right against the ring after reconnecting.