1
2
3
4
For 1, 2 and 4
For 3
Attaching the flying lines
Attach the top lines to top line attachments at 2
and 3, attach the rear lines to the rear leader
lines at point 1 and 4.
Place a larkshead knot in the sleeve of the flying line and slide it over the knot on the leader
line. Tighten the larkshead knot, and slide it against the end knot on the leader line.
Slide the sleeve on the end of the flying line (A) through the ring on the end of the top line
attachments (B) and through the ball with tubing (C). Place the loop on the end of the leash
(D) through the sleeve (A) and place the other end of the leash (E) through this loop. Pull
this larkshead tight and pull the flying line back through, so the knot sits inside the ball (C).
Make sure the tubing goes
through
the ring (B). We advise you to check this before every
launch!
Check that the tube
sits inside the ring
before EVERY
launch!
A
B
C
D
A
E
C
D
B
A
