12
TURNING ON AND OFF
The transmitter is always in a permanent sleep state.
It is only ON when a button is being pressed and does
not need to be turned off by the user. If the transmitter
does not activate, make sure you have a good battery
installed.
NOTE
If the
red
LED on the transmitter flashes rapidly after any
button is pressed, the 9-volt battery may need to be re-
placed. If the SmartLED™ on the collar unit double-
flashes while ON, the unit will need to be recharged. If the
SmartLED™ double-flashes soon after a full charging ses-
sion, the rechargeable battery may need to be replaced.
Turning the Collar Unit ON/OFF:
Turning the collar unit ON and OFF
uses the same procedure:
1. Hold the transmitter magnet
indicator (
red dot
) directly against
the magnetic activation switch (
red
dot
) on the front side of the collar unit.
2. The SmartLED™ indicator will light solid for about
a second and then start flashing. Remove the
transmitter from the collar unit when the
SmartLED™ light begins to flash.
If the collar unit has been turned ON, the SmartLED™
will flash approximately every other second. If the
collar unit has been turned OFF, the SmartLED™ will
no longer be flashing.
