9
Battery Charging Receptacle
The battery charging receptacle is located on the
bottom side of the collar box. Always close with the
rubber plug after charging to prevent foreign particles
from getting inside the charging receptacle.
NOTE
The unit is still waterproof even if water gets into the
charging receptacle. However, if water should get in, we
recommend rinsing out the charging receptacle and allow-
ing it to dry, especially after use in salt water. This will
prevent premature corrosion in the metal pins inside that
make contact with the charger plug.
Magnetic On/Off Switch Indicator (Red Dot)
The red dot indicates the location of the
magnetic power switch in the collar re-
ceiver and is used to turn the collar re-
ceiver ON/OFF and for ID Programming.
PARTS & FUNCTIONS
CAUTION
If your collar belt is too long , we recommend looping the
excess Collar Belt back around through the buckle. We
DO NOT recommend cutting the collar belt. Cutting the
collar belt too much will reduce the range of your collar
receiver. However, if you must, the collar belt can be cut
up to about 3 inches without affecting the range greatly.
Collar Belt with MAXX-Range 360™ Antenna
The embedded collar antenna is woven into the bright
orange reflective collar belt and runs the entire length
of the belt. The MAXX-Range 360™ antenna gives
the collar receiver 360˚ of clear signal reception.
