Outlet / Electric Current Protector / Power Switch
Manual Control Button
Manual control button & Power switch illustration
IR remote control instruction manual
Remote control button key illustration
7
E.SW
Stop motor emergent. Turn on
power switch to restart the
machine.
START
To start the machine
STOP
To stop the machine
SPEED UP
Speed up set up(1-12Km)
SPEED
DOWN
Speed down set up(12-1Km)
Outlet
Input AC Power
Electric
Current
Protector
Cut off the AC Power while over
current
Power
Switch
[
O
]=Power OFF, [
|
]=Power ON
No.
Name
Definition
1
Red LED Light
Infrared signal light
2
[ RESET ]
Stop machine and go back to set up
mode
3
LCD Window
Time: count up/down 00 ~ 99 min.
Speed: up/down 00.0 ~ 99.9 km/h
(Imperial system will not shown)
4
IR transmitter Infrared rays transmittance
5
[ TM ]
To set up time
6
[ CLR ]
Clear time setting, and back to set up
mode
7
[ START ]
Start the machine
8
[ STOP ]
Stop the machine
9
[ MODE ]
Speed / Distance display exchange
10
[ SPD ]
Speed setting
11
[ S.KEY ]
Push [S.KEY] + [MODE] to set up
remote control channel
Electric Saving Mode
The LCD display will access into
electric saving mode if no setting
over 1 minute. Push any key to go
back the normal display besides
[RESET] key
Battery
NO. 4 1.5V Alkaline Battery x 2 pcs
Infrared rays receiving range
IR receiving range achieved
180
∘
both left and right sides.
Remote control operation
8
[START]
[SPD]
Speed Setting
(1.0~12.0Km)
[STOP]
Stop automatically
when time reached
99:59 min.
[TM]
Time Setting
(00:00~99:00min.)
[START]
[CLR]
Time resetting
Regular Mode
(W/O Time Setting)
Time Setting Mode
[RESET]
[RESET]
After push
[STOP
] key, the long beep
sound will come out after 3-6 seconds.
Then you can restart the machine.
[SPD]
Speed Setting
（
1.0
～
12.0
Ｋｍ）
[STOP]
Stop automatically
when time reaches
00:00 min.
After push
[STOP
] key, the long beep
sound will come out after 3-6 seconds.
Then you can restart the machine.
