www.petsafe.net
9
Operating Guide
Prepare the Remote Transmitter
Charge the Remote Transmitter
1. Lift the rubber cover protecting the Remote
Transmitter Charging Jack.
2. Connect one of the charger connectors to the
Remote Transmitter Charging Jack.
3. Plug the charger into a standard wall outlet.
4. Charge the Remote Transmitter for 5 hours for the
first charge. Recharges take only 3-4 hours.
Note:
The Battery Indicator will scroll while charging and
will become solid when fully charged.
5. When charging is completed, replace the rubber cover.
Note: Approximate battery life between charges is 40
to 60 hours, depending on frequency of use.
Charger
connector
placed in the
Handheld
Transmitter
Charging Jack
Turning ON the Transmitter
Power up the Transmitter by pressing any button. You will see the display turn on when
you press any button.
Transmitter Digital Display
The display stays on for 1 minute after a button is pressed. After 1 minute with no buttons
pressed, the display shuts off and the Transmitter goes into battery conservation mode.
Pressing any button will cause the display to turn back on. The various display symbols
are explained below.
Numeric
readout
Displays the stimulation level for Dog 1 or Dog 2.
Dog 1/ Dog 2 The symbol displayed is the active dog receiver
collar. See Two Dog System on page 14.
Tone or
Stimulation
When pressing Tone or Stimulation the Dog 1 or
Dog 2 symbol will appear in bold or emphasized.
Step
1