www.petsafe.net
5
Fit the Anti-Bark Collar
Important: The proper fi t and placement of your Anti-Bark Collar is
important for effective operation. The Contact Points must have direct
contact with your dog’s skin on the underside of his neck.
To ensure a proper fi t, please follow these steps:
1. Make sure that the battery is not installed in the Anti-
Bark Collar.
2. Have your dog standing comfortably.
3. Centre the Contact Points underneath your dog’s neck,
touching the skin.
YES
NO
Note: It is sometimes necessary to trim the hair
around the Contact Points to make sure that contact
is consistent.
4. The PetSafe QuickFit™
Collar is designed so you
can quickly attach and
remove the Anti-Bark
Collar from your dog
while maintaining the
desired fi t.
a. With the Snap Buckle
fastened, thread the
collar through the
Metal Buckle.
b. Slide the excess collar through the “C” Loop on
top of the Snap Buckle. This will hold the collar in
place.
c. Once the collar fi t is determined, simply use the
Snap Buckle to remove and replace the collar.
5. The Anti-Bark Collar should fi t snugly, yet loose
enough to allow one fi nger to fi t between a Contact
Point and your dog’s neck. Allow your dog to wear the
collar for several minutes, then recheck the fi t. Check the fi t
again as your dog becomes more comfortable with the Anti-
Bark Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Anti-Bark Collar from your dog and cut off
excess.
Snap Buckle
“C” Loop
Metal Buckle
Summary of Contents for Anti-Bark Collar
Page 41: ...www petsafe net 41 ...
Page 42: ...42 www petsafe net ...
Page 43: ...www petsafe net 43 ...
