10
1-800-732-2677
Set the Boundary Width
and Test the Receiver Collar
The Boundary Control Switch on the side of
the Fence Transmitter has three settings (
6A
).
Setting
B
is used for most properties. The
following table will indicate the setting you
should use.
Amount of Wire
Setting
Up to 1300 feet
B
1300-2400 feet
C
Greater than 2400 feet
A
Use the Boundary Width Control knob to set the
width of the Warning Zone and Static Correction
Zone (
6B
). Set the Boundary Width as wide as
possible to give your pet the widest Warning and
Static Correction Zones without reducing the
Pet Area too much.
6A
5
2
8
4
10
3
9
1
7
0
6
5
2
8
4
10
3
9
1
7
0
6
6B
Note: The Boundary Width Control knob does not change the Static Correction Level.
To identify the Warning and Static Correction Zones, make sure the Receiver Collar battery is properly installed, the
Static Correction Level is set at 2 or above, and the Test Light contacts are held to the Contact Points (
6C
). Walk toward
the Boundary Wire holding the Receiver Collar at your pet’s neck level (
6D
) until the Receiver Collar beeps (
6E
).
Note: The Receiver Collar is waterproof, which can make the beep hard to hear.
If the Receiver Collar does not beep at the desired range, adjust the Boundary Width Control knob to the desired
setting. Turning the Boundary Width Control knob clockwise increases the Boundary Width while turning it
counterclockwise decreases it (
6B
). Repeat this activity as needed until the Receiver Collar beeps at the desired
distance from the Boundary Wire.
The numbers on the Boundary Width Control knob indicate signal strength and are not representative of Boundary
Width footage. If adjusting the Boundary Width Control knob does not give the desired range, adjust the Boundary
Control Switch to another setting to achieve your desired range. If using a Double Loop, you may need to increase
the separation of the Boundary Wire to achieve the desired range.
The Receiver Collar beeps as a warning tone and ticks when delivering a Static Correction. After hearing the beep,
continue to walk towards the wire. The Receiver Collar should tick and the Test Light should fl ash, indicating the
Static Correction as you enter the Static Correction Zone (
6E
). A warning beep and the fl ashing of the Test Light
indicate that the Receiver Collar and the system are working properly and that you are ready to start burying the
Boundary Wire. If the Receiver Collar did not beep or the Test Light did not fl ash, refer to the “Troubleshooting”
section.
Note: The Boundary Width is broken down into 20% Warning Zone and 80% Static Correction Zone.
6C
Boundary
Wire
6D
6E
Step
6
Summary of Contents for Comfort-Fit System
Page 21: ...www petsafe net 21 ...
Page 22: ...22 1 800 732 2677 ...
Page 23: ...www petsafe net 23 ...
