Petsafe D360-RE Quick Start Manual Download

Page: 6 / 8

Customer Care 1 (800) 732-2677

12. Rinse the carbon filter under water and insert it into

the housing with the pull-tab facing up.

13. Screw on the filter housing cap.

14. Align the side grooves of the housing with the inner

notches of the cone opening.

15. Turn housing clockwise until it locks in place.

16. Place 1 of the 5 spout rings on top of the housing

cap and press down to secure.

Summary of Contents for D360-RE

Page 1: ...D360 RE Drinkwell Plastic 360 Pet Fountain Please read this entire guide before beginning Quick Start Guide ...

Page 4: ...ide 2 2 Flip the bowl upside down and unhook the electrical cord from the 2 cord clips Pull the cord through the cord pass through in the bowl 3 3 Remove the intake tube from the pump by lifting up 4 Remove the pump from the bowl 5 5 Take the pump apart by first removing the faceplate You may need to use a fingernail to pry it off Unlocked Cord Clips ...

Page 5: ...8 Rinse all fountain components except for the power adaptor with warm water before using the pet fountain This will remove any residue from the manufacturing process 9 Reassemble the fountain 10 10 Remove the flow control cap from the filter housing by lifting up Gently lift up on the spout ring to access the filter housing cap 11 11 Unscrew the filter housing cap ...

Page 6: ...the housing with the pull tab facing up 13 13 Screw on the filter housing cap 14 14 Align the side grooves of the housing with the inner notches of the cone opening 15 Turn housing clockwise until it locks in place 16 16 Place 1 of the 5 spout rings on top of the housing cap and press down to secure ...