www.petsafe.net 7
T-CN
S-CN
EN
Operating Instructions
Important:
DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
1. As with any electrical device, check the electrical Power Cord for any tears or
damage before use.
2. Make sure the Inline Plug is connected. (No silver showing)
3. Remove the Housing Lid by placing your index fingers into the inset groves on
either side of the Housing Lid. Lift up. Set the Housing Lid aside.
4. Lift up the Reservoir and
check to make sure the
Intake Tube is properly
inserted into the Pump
(
fig. 1 & 2
).
5. Insert the Charcoal Filter. The Charcoal Filter will fit into the two triangular slots in
the centre of the Housing. The Charcoal Filter fits narrow side down and the black
side faces the front of the Pet Fountain. The Charcoal Filter will slide easily into place.
NOtE:
Rinse the Charcoal Filter thoroughly under cool
water before placing into the Housing. This will remove
any loose charcoal dust, which is harmless. A small
amount of charcoal dust may shed for the life of the
Charcoal Filter. This is normal and not harmful to your
pet (
fig. 3
).
6. Place the Pet Fountain in desired location. Do not
pick up a full Pet Fountain by the Housing. Only
use the handles located on the bottom of the Bowl
on either side of the Pet Fountain. If placing on carpet, tile or wood flooring
use a protective surface such as a towel or placemat to protect your floor from
splashing or dripping from your pet.
7. Fill the Pet Fountain with water. This includes the Bowl and the Housing. This will
prime the Pump. Replace the Housing Lid and snap into place.
fig. 1
fig. 2
fig. 3
