www.petsafe.net
65
1) As with any electrical device, check the electrical cord for any
tears or damage before use.
2) Make sure the inline plug is fully connected. (No silver showing)
3) Remove the housing cover (lid) by placing your index fingers into
the inset grooves on either side of the lid. Lift up. Set the
lid aside.
4) Insert the charcoal filter. The filter
will fit into the two triangular slots
located on the right side of the
housing. The filter fits narrow side
down and the white side faces the
front of the fountain (as shown in
Fig. 1a). The filter will slide easily
into place, but make sure it is
pushed all the way down.
NOTE: Rinse the filter thoroughly under cool water before placing
in the fountain. This will remove any loose charcoal dust, which is
harmless. A small amount of charcoal dust may shed for the life of
the filter. This is normal and not harmful to your pet.
5) Place fountain in desired location. If placing on carpet, tile or
wood flooring use a protective mat or other durable, water
resistant surface to protect your floor from splashing or dripping
from your pet.
6) Fill the unit with water. This includes both the bowl and the filter
housing. This will prime the pump. Replace the lid.
7) Before you plug the fountain in, make sure the cord and your
hands are dry. Plug the fountain into an electrical outlet.
Fig. 1a
DO NOT RUN DRY - FOR INDOOR USE ONLY
OPERATING INSTRUCTIONS
