14
Customer Care Center 1-800-732-2677
3. Press
RIGHT
button to move to the hour field to set the time for meal
1
.
4. Use
UP
or
DOWN
buttons to set hour for meal 1. If in 12 hour time format, set hour
with desired
AM
or
PM
setting. Press
RIGHT
button to move to minute field.
5. Use
UP
or
DOWN
buttons to set minute. Each meal time can be set in 15 minute
increments. Press
RIGHT
button to move to meal size field.
6. Use
UP
or
DOWN
buttons to set desired meal size. Meal size can be adjusted in
1/8-cup (30 ml) increments, with a minimum portion of 1/8-cup (30 ml) to maximum
portion of 4-cups (946 ml).
7. Press
RIGHT
button to move back to meal number
field. Use
UP
button to move to next meal, which is
meal 2. The LCD screen should show time of
5:00 PM
(17:00 if in 24 hour format) and meal size of
2 cup
,
unless a different meal was previously setup. To
schedule a second meal, press
RIGHT
button to
move to hour field to set time. Repeat steps 4 through 7 for as many meals (up to 12)
you want to schedule.
Note:
Up to 12 meals can be scheduled. For any of the 12 meal options you do
not want to schedule, leave the meal size fields blank or set to “--- cup” or “--- ml”
.
8. After programming desired number of meals, return to the meal number field. Press and
HOLD
ENTER
button for 5 seconds to program feeding schedule and enter
Operating
Mode
(see
“Operating Mode”
page 15 for more details). The LCD screen will then
display the time and size of next scheduled meal.
2C.
Fill With Food:
Do NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY.
Check operation frequently to be sure the pet feeder is dispensing
properly. For dry food use only. DO NOT use wet, canned or moist
food. Pet feeder should be placed on a level surface.
Do not install or store pet feeder where it will be exposed to weather or
temperatures below 40° F.
Place feeder in desired location. Fill feeder hopper with dry or semi-moist pet food,
allowing room to replace lid.
To Replace Lid:
Align front tab on lid into slot behind
the control panel. Lower back of lid and push down
until lid latch snaps into place.
To Prepare Conveyor with Food:
If buttons are
locked, press
ENTER
and
UP
buttons
AT SAME
TIME
to unlock. Next press
ENTER
and
LEFT
buttons
AT SAME TIME
to prepare feeder conveyor
to dispense food. Release buttons when you hear
conveyor moving and filling each section with food
getting ready for the first scheduled meal. Pieces
of food may be dispensed into the bowl. Pour any
dispensed food back into hopper. Every time the
hopper is empty or almost empty and is refilled with food, the conveyor must be prepared.
Note:
If conveyor is not prepared as instructed, no meal or incorrect meal sizes
will be dispensed. Ensure conveyor is properly prepared with food every
time hopper is refilled.
Example Meal: