www.petsafe.net 17
Care and Cleaning
The Healthy Pet Simply Feed
™
comes apart for easy cleaning. The washable parts are:
stainless steel bowl, bowl holder, hopper lid, hopper and conveyor. The stainless steel bowl,
bowl holder, hopper lid and hopper are dishwasher safe. Only clean the conveyor by
hand-washing using cool or warm soapy water. These washable parts can be submerged
in water. Rinse and let all parts air dry completely before assembling feeder.
DO NOT use
hot water, submerge the hopper base in water or clean the conveyor in an automatic
dishwasher.
Do NOT immerse control panel in water. Base unit should NOT be
submerged in water at any time, as this may damage electronic
components.
To Clean Feeder:
1. If you have any food in the feeder, press
UP
and
ENTER
buttons
AT SAME TIME
to
unlock 5-Button Navigation. Next run the
“To Prepare Conveyor with Food”
cycle (see
page 14) by pressing the
ENTER
and
LEFT
buttons
AT SAME TIME
. This will dispense
any food remaining in the conveyor and hopper into the bowl. Repeat the
“To Prepare
Conveyor with Food”
until no more food is dispensed or just a few pieces of food are
dispensed from the feeder.
2. Set feeder to
PAUSE FEED MODE
. This keeps the
conveyor in sync with the feeding schedule when
reassembled.
3. Remove stainless steel bowl from bowl holder by
first lifting up back of bowl and then front.
5. Remove lid by pulling back finger latch then lifting
up using finger grips (see
“Remove From Package”
page 10).
6. Remove hopper by pressing hopper release button on back of feeder then lift to remove
(see
“Clean Removable Parts”
page 10).
7. Remove conveyor by pulling back red conveyor latch to unlock. Lift to remove (see
“Clean Removable Parts”
page 10).
8. Remove conveyor crumb catcher by gently
pressing in sides and pulling down.
9. Remove bowl
holder by
releasing one tab
on inside of
feeder base
using a finger nail
or screw driver
while gently
pulling down on
same side of
bowl holder from
the outside.
Release other
tab and pull
down other side
of bowl holder.