petsafe.com
13
Set the Static Correction Level
The static correction levels increase in strength from 2 to 6, with level 1 being tone
only (no correction), and level 6 being the maximum setting. Refer to the table on
the following page to choose the static correction that best fits your pet.
To set or check the static correction, press and hold the mode button until you
see a red light. Then let go. The collar will then emit a series of red flashes that
correspond to the current correction level (e.g., 4 red flashes means level 4). Press
and hold the mode button again for 1 second to increase the level by one setting.
You must count the number of red flashes to determine the level setting.
Note:
Once you count 6 red flashes you are at level 6, and an additional hold
will cycle the receiver collar back to level 1, which is tone only.
Refer to the table “Receiver Collar Status Indicators” on page 21 for a complete
guide to all the status lights and tones for the receiver collar.