+1 (800) 732-2677
16
You may need to trim the hair in the area of the contact points. Never shave
your pet’s neck; this may lead to a rash or infection.
2. Check the tightness of the receiver collar by inserting one finger between
the end of a contact point and your pet’s neck. The fit should be snug but
not constricting.
3. Allow your pet to wear the receiver collar for a few minutes, then check it again.
4. Once you are satisfied with the fit of the receiver collar, remove it from your
pet and trim it, but make sure to allow room for growth or a thicker winter
coat. Use a lighter to seal the cut so that it will not fray (
3B
).
5. The collar will slip if it is not properly threaded. The slide buckle prevents the
collar from becoming loose around your pet’s neck and the ridges must be
facing up (
3C
).
6. While the receiver collar is still off your pet, turn it on by holding the mode
button until a green light comes on. The first thing your receiver collar does
is a ReadyTest
®
startup (page11) to ensure that it is ready for use. You will
know it is done when the indicator flashes the series of red flashes to indicate
the current static correction level. Do not touch the contact points during the
ReadyTest startup.
7. Once the ReadyTest startup is done, the receiver collar will automatically go
through an optional PerfectFit
Test (page 12), which lasts for 90 seconds. This
mode begins with simultaneous flashing red+ green lights.
8. Place the collar on your pet and adjust the fit.