6
1-800-732-2677
Ensure a Proper Spray Pattern
For the PetSafe
®
Little Dog Spray Bark Control Collar to perform properly, the nozzle
must be positioned correctly and there must be a clear path from the Spray Nozzle to
your dog’s snout. Follow these steps:
1. Make sure the PetSafe logo on the front of the
unit is upright and the Spray Nozzle is angled out
and pointing up towards the dog’s snout.
2. For long-haired dogs, it may be necessary to trim
the neck hairs along the path of the spray. It is
important that the spray reaches the dog’s snout
to be effective.
_______________________________________________________________________________________
On/Off Battery Module
The PetSafe
®
Little Dog Bark Control Collar is packaged with the battery module
installed in the “OFF” position. To activate the collar, use a coin to turn the Battery
Module counter clockwise until the arrow lines up with the “ON” position. If
the PetSafe
®
Little Dog Bark Control Collar is not going to be used on the dog
immediately leave it in the “OFF” position.
_______________________________________________________________________________________
To Insert and Remove the Battery
Note: Do not install the battery while the Bark Control Collar is on your dog.
A replacement PetSafe battery (RFA-188) can be found at many retailers. Contact the
Customer Care Center at 1-800-732-2677 or visit our web site at www.petsafe.net to
locate a retailer near you.
ON OFF
ON OFF
