12 www.petsafe.net
www.petsafe.net 13
EN
ES
FR
IT
NL
DE
SteP 5
Install Pet Door
optional Support Installation:
5A.
Optional:
Measure from inside of exterior wall to inside of interior
wall. Cut a board to the measured length (W), making sure cut is
square. Remove any debris inside wall where support will
be installed.
Make sure support fits snug and is not too long or too
short to prevent damage to wall.
5B.
Optional:
Place cut board support inside wall so
top of support is flush with bottom of interior and
exterior cut-outs. Use 2 drywall or wood screws
(not included) to fasten support to interior wall.
If installing screws into vinyl siding, it may be necessary
to drill a hole slightly larger than screw head so screw
tightens flush and does not buckle the vinyl siding.
5C.
Optional:
Use 2 drywall or wood screws (not included) to fasten
support to exterior wall.
5D.
Measure cut-out from outside of exterior wall to
outside of interior wall (T). Note the measurement.
5e.
Screw a binder post onto screw rod end without
the nut. Use the binder post as a guide and cut
screw rod to a length of (T) + 2”(51 mm). After the
cut, remove the binder post to help straighten the
threads. Repeat with each screw rod.
Note: After cutting the screw rods ensure the
threads are smooth. If there are burrs use
sandpaper or a file to remove the burrs so
the screw binders screw easily over
the threads.
5f.
Using a
7
⁄
32
” (6 mm) drill bit, drill through
the four outer screw holes from front side
of interior frame. Do not forget the screw
hole(s) inside battery compartment. Turn
frame over and drill through back side of
same screw holes on interior frame.
5A
5A
Optional
5A
5B
Optional
5C
Optional
5D
5e
7
/
32
"
(6 mm)
5f
