www.petsafe.net
3
• Read this entire guide prior to cutting or modifying an opening in your door
or wall. Do not proceed with cut-out or installation until your PASSport
™
is
assembled, powered up, programmed for your pet and all steps under “Prepare,
Test and Setup” have been completed.
• Keep these instructions with important papers; be sure to transfer these instructions
to the new owner of the property.
• Unauthorized changes or modifications may void the user’s authority to operate
this equipment, and void the warranty.
• Read this entire guide prior to cutting or modifying an opening in your door
or wall. Do not proceed with cut-out or installation until your PASSport
™
is
assembled, powered up, programmed for your pet and all steps under “Prepare
and Test PASSport
™
” have been completed.
• We do not accept any responsibility for openings that are cut or modified in
doors or walls or any damage caused to doors or walls in forming or
modification of such openings, including any costs associated with the repair or
replacement.
• If operating from the optional Rechargeale Lithium battery, the battery and bat-
tery compartment coannot be exposed to temperatures below 32°F (0°C).
• If homeowner’s door or other application is not level, the pet door must be
marked level to swing properly.
• When applying the cutting template, there should be a minimum of 3”
between the bottom and sides of the door and the outer edge of the template to
maintain the structural integrity of the door.
• Make sure there is nothing underneath the door where you will be drilling holes
or cutting out the opening.
• Use a manual screwdriver to tighten screws. Do not over-tighten.
Over-tightening can strip the screws or warp the pet door frame.
