Petsafe PAW POINT PIF00-13651, Operating And Training Manual

30 1-800-732-2677

Do I need to perform maintenance 

on my Wireless Mapping Fence?

• Yes. Check your pet’s neck daily for irritation from the Contact Points.

• Check the Contact Points on the Receiver Collar weekly to make sure they 

are clean.

• The Contact Points are designed to be hand tightened. Do not over tighten.

• Check the fit of the Receiver Collar weekly.

• The Receiver Indicator Light acts as a Battery Status Indicator, flashing red 

every 4 to 5 seconds when battery charging is required.

How do I know the battery in the 

Receiver Collar is charged?

• Check Battery Status Indicator Lights. Light will flash green or red/green 

or red indicating the charge status of the battery.

Will vehicles, buildings and landscape 

features (trees, shrubs, etc.) affect the 

performance of the Wireless Mapping 

Fence?

• Yes. Placing the Transmitter inside a metal building can reduce the maximum 

range of the Wireless Mapping Fence.

• Parking a vehicle near the boundary, can reduce the range in that area and 

cause your pet to receive a Static Correction where it otherwise would not if 

the vehicle was not there. 

• Fixed large metal objects such as metal sheds can affect the signal by 

reducing the maximum range of the system at the location of the object.

What do I do if my pet’s neck 

becomes red and irritated?

• This condition is due to the Contact Points irritating the skin. Discontinue 

use of the Receiver Collar for a few days. If the condition persists beyond 

48 hours, see your veterinarian. Once the skin returns to normal, replace 

the Receiver Collar and monitor the skin condition closely.

Can I attach a leash to the Receiver 

Collar?

• No. This can result in pulling the Contact Points too tightly against your 

pet’s neck or the collar may break. Attach a leash to a separate, non-

metallic collar positioned above the Receiver Collar.

Why does my Receiver Collar have a 

tone only mode?

• The tone only mode can be used in training your pet to his boundary or for 

well-trained pets that no longer require Static Correction.

What is the maximum distance the 

Receiver Collar can operate from the 

Transmitter?

• 90 feet.

Troubleshooting

The Receiver Collar is not beeping 

when setting up the Warning Zone.

• Make sure Receiver Collar is turned on and Battery Status Lights are 

flashing every 4-5 seconds.

• Charge Receiver Collar.

• Be sure the Receiver’s 

PetSafe

®

 logo always faces the direction of 

motion

 when carried by hand. 

• Be sure the 

logo always faces toward the dog’s chin

 when collar is on 

dog. 

• Try reconnecting to the BPU to verify if Receiver Collar still functions 

correctly with the BPU in Flag Test mode.

• The beep may be difficult to hear in a noisy environment. 

• Use Test Light as explained in the “Test Light Instructions” section, and 

use it to determine the location of Warning Zone.

The Receiver Collar is not beeping or 

administering a Static Correction.

• Make sure Receiver Collar is turned on and Battery Status Lights are 

flashing every 4-5 seconds.

• Charge Receiver Collar.

• Be sure the Receiver’s 

PetSafe

®

 logo always faces the direction of 

motion

 when carried by hand. 

• Be sure the 

logo always faces toward the dog’s chin

 when collar is on 

dog. 

• Try reconnecting to the BPU to verify if Receiver Collar still functions 

correctly with the BPU in Flag Test mode.

• Check that the Transmitter is plugged into a working AC outlet, the 

Power Light is on.

The Receiver Collar is beeping inside 

the house.

• Remove the Receiver Collar from your pet when indoors to avoid 

activation of the Receiver Collar.