![background image](http://html1.mh-extra.com/html/petsafe/pawz-away-znd-1200/pawz-away-znd-1200_operating-and-training-manual_1532546013.webp)
www.petsafe.net 13
Programming the Mode Settings
All programming is done through the Barrier Transmitter and the programming is synchronized
with the Receiver Collar. The Receiver Collar cannot be programmed separately from the
Barrier Transmitter.
You may synchronize multiple Receiver Collars to a single Barrier Transmitter at one time.
However, make sure any Receiver Collar you do not wish to synchronize is turned OFF during the
programming procedure. Any collar that is within 5 feet of the Barrier Transmitter and turned ON
may be reprogrammed. Familiarize yourself with the steps outlined below before attempting to
program the Barrier Transmitter and Receiver Collar.
CAUTION
To prevent an unintended correction, do not perform set up procedures while the
Receiver Collar is on your pet.
Gather the Receiver Collar(s) you wish to synchronize with the Barrier Transmitter. Turn the
1.
Receiver Collar(s) ON and place less than one foot from the Barrier Transmitter.
Turn the Barrier Transmitter OFF by pressing the DOWN (-) arrow button until there are no
2.
bars displayed in the LCD window. Remove the battery door.
The mode switch is located inside the
3.
transmitter and is preset to mode A.
Move the switch to the center position for
mode B or to the right position for mode
AB (5A). Once you have selected the
desired mode, replace the battery door.
Note: If you have selected mode AB you do
not need to proceed with programming the
receiver in the next steps. Receiver Collars
set to mode A or mode B will each receive
the radio signal from a Barrier Transmitter
set to mode AB.
Inside
Battery
Door
Transmitter
Inside View
5A
To program the Receiver Collar to either mode A or mode B, press and hold the DOWN
4.
(-) arrow button and then press the UP (+) arrow button for approximately 5 seconds.
Programming is complete when you hear a series of three beeps from the Receiver Collar.
Once the Receiver Collar has been programmed, press the UP (+) arrow button to turn the
5.
Barrier Transmitter ON. Check to make sure the black bar(s) appear on the LCD screen
indicating the mode you have selected (5B) and reset the Barrier Transmitter to the desired range.
Mode A
Mode B
Mode AB
5B
Summary of Contents for Pawz Away ZND-1200
Page 18: ...18 Customer Care Center 1 800 732 2677 ...
Page 19: ...www petsafe net 19 ...