10
Customer Care Center 1-800-732-2677
www.petsafe.net
11
PerfectFit
™
Test for Collar Fit
This test is an added feature to verify fit but is not required for the system to
function. After the ReadyTest
®
, the Receiver Collar will go into PerfectFit
™
test
mode. This mode begins with a flashing yellow light. To use this feature, you
must place the Receiver Collar on your dog within 90 seconds of removing
it from the Collar Charger. The Receiver Collar will emit a chime tone as the
Contact Points touch your dog’s skin. You will know you have the proper
fit when the collar chimes and flashes green 5 consecutive times. After 90
seconds, the Receiver Collar moves into normal operation mode.
The Receiver Collar will still function normally if you are unable to place the
Receiver Collar on your dog within 90 seconds of removing it from the Collar
Charger. If you wish to use the PerfectFit
™
test after 90 seconds have passed,
place the Receiver Collar back on the charger for 5 seconds. Remove the
collar and allow it to complete the ReadyTest
®
before placing it on your dog.
Receiver Collar Status Indicators
The Receiver Collar Status Indicator Light along with the Receiver Collar
Alarm Tone are used to determine the operational mode, the battery status,
and the correction type. Refer to the Receiver Collar Status Indicator Table to
understand the status lights and tones for the Receiver Collar. During normal
operation, the Receiver Collar Indicator Light will flash every
3 seconds to indicate the battery status as shown in the table that follows.
Summary of Contents for Ultrasmart PIG00-13620
Page 27: ...www petsafe net 27...
