22
Customer Care Center 1-800-732-2677
www.petsafe.net
23
Test Light Instructions
1. Make sure the Receiver Collar battery is fully charged.
2. Hold the Test Light contacts to the Contact Points (
K
).
3. Hold the Receiver Collar at your dog’s neck height
with the Contact Points pointing up (
L
) and the
www.petsafe.net website on the receiver facing the
Boundary Wire.
K
4. Slowly walk toward the Boundary Wire until you hear the warning tone (
M
).
5. Two seconds after the warning tone, the test light will begin to flash.
Note: The Receiver Collar is
waterproof, which can make the
beep hard to hear.
Save the Test Light for future testing.
If the Receiver Collar did not beep
or the Test Light did not flash, refer
to the Troubleshooting section in
your PetSafe
®
UltraSmart
®
In-Ground
Fence
™
Operating and Training
L
Boundary
Wire
M
Guide or contact the Customer Care Center.
Summary of Contents for Ultrasmart PIG00-13620
Page 27: ...www petsafe net 27...
