24
How the remote control buttons work
Vibration selection („
“)
The vibration intensity is adjusted by one level each with the up and down
keys.
Tone only button (upper button „TONE“)
Sends an audible tone to the trainer. No vibration is delivered.
Vibration only button (middle button „VIBRA“)
Delivers vibration through the contact area on the remote control at the
level shown on the digital display. When held down for ten consecutive
seconds, the trainer will “time-out”, and vibration cannot be delivered
for five seconds. You must release and press the button again after the
five second time-out period, before additional vibration can be delivered.
Dog Toggle Switch (lower button „1|2“)
The switch button allows the user to choose between two different
trainers. Thus two trainers can be used with one remote control.
PetTec-Tipp:
To connect a second trainer, please set the toggle switch to 2 and switch on
the trainer to be connected. The new trainer connects to the remote control by
simultaneously pressing the tone signal and vibration buttons.
More on page 32.
2
3
4
1
