32
How to pair remote control and trainer
If your trainer does not beep when the TONE button of the remote control is
pushed, or if you feel the trainer is not responding to the remote control, follow
these steps to pair:
Proper dog training
Proper training is the key to a harmonious coexistence between dog and
owner. But we can often reach the limits of our abilities when training our four-
legged friends. The Remote Vibra Trainer 2.0 is a gentle dog-training aid which
helps to effectively discourage your pet from undesirable behaviors.
With the Remote Vibra Trainer 2.0 you can intervene directly, even from a
distance, to immediately react to bad habits. Most dogs permanently adjust
their behavior after just one or two uses of the trainer. Please note that the
trainer is a training device and not a toy, and always should be used with care.
So at this point we ask you to observe the following guidelines:
Pairing a second trainer
With the trainer off your pet, turn the trainer off. Restart, press and hold
the On/Off button until the green LED light flashes every second on the
trainer. This continues for 16 seconds, within which pairing should be
completed.
Press and hold the TONE and VIBRA button of the remote control at the
same time until the green LED light on the trainer flashes rapidly for 5
times, indicating pairing is completed.
Set the toggle switch from 1 to 2.
Turn on the trainer of dog 2, press any mode buttons to verify function.
If dog 2 trainer does not respond, pairing may be needed.
Repeat steps in „How to pair remote control and trainer“.
1.
2.
1.
2.
3.
