3
COMFORT
46
You must programme your departure time
in order for the system to calculate the op-
timum heater start time automatically.
Programming the heating
Set the time by pressing the buttons
1
and press buttons
4
and
5
simultane-
ously to save it.
Programming the departure time
Press the buttons
1
to display the pro-
gramming time.
This symbol is displayed.
Once the programming time has been
displayed, press buttons
4
and
5
si-
multaneously within 10 seconds.
This symbol fl ashes.
This symbol is displayed (fi xed).
Once the programming time has been
displayed by means of the buttons
1
,
press button
5
(ON) until the message
"OK"
appears.
Activation - deactivation
When the signal has been received,
the message
"OK"
is displayed
along with the symbol
"HTM"
.
To deactivate the programming, press
button
4
(OFF) until the message
"OK"
appears.
HTM: Heat Thermo Management.
The symbol
"HTM"
is switched
off.
When carrying out these op-
erations, if the message
"FAIL"
appears, the signal has not been
received. Repeat the procedure
after changing your location.
This symbol is displayed when
the heater starts.
Switching off the heating
Press button
5
(ON).
The symbol
"HTM"
remains on.
Changing the level of heating
The system offers
5 levels
of heating
(from the lowest level
C1
to the high-
est level
C5
).
Once the level of heating has been
displayed by means of the buttons
1
,
press buttons
4
and
5
simultaneously.
The letter
"C"
fl ashes.
Set the level of heating by pressing
the buttons
1
.
Press buttons
4
and
5
simultaneously
to save the level selected. The letter
"C"
is displayed (fi xed).
The factory pre-sets are re-
placed by the new settings
entered. The programmed
times are stored until the next
time they are changed.
When the departure time is acti-
vated, the level of heating cannot be
changed. The departure time must be
deactivated fi rst.
Summary of Contents for 407 2010
Page 15: ...1 18 ...
Page 34: ...3 COMFORT 34 ...
Page 155: ...11 11 TECHNICAL DATA 135 DIMENSIONS IN MM 407 saloon 407 SW ...