3
COMFORT
47
Always switch off the programmable
heating while fi lling with fuel to avoid
any risk of fi re or explosion.
To avoid any risk of poisoning and as-
phyxiation, the programmable heating
must not be used, even for short peri-
ods, in an enclosed space such as a ga-
rage or workshop which is not equipped
with an exhaust gas extraction system.
Do not park the vehicle on an infl am-
mable surface (dry grass, dead leaves,
paper…), there is a risk of fi re.
The programmable heating system
is supplied by the vehicle's fuel tank.
Before use, ensure that the quantity of
fuel remaining is suffi cient. If the fuel
tank is at the reserve, we strongly ad-
vise that you do not programme the
heating.
Changing the battery
The remote control is supplied by a
6V-28L battery, which is supplied.
Information on the display indicates
when it is time to replace this battery.
Unclip the casing then replace the
battery.
The remote control must then be reini-
tialised, see below.
As an accessory, your pro-
grammable heating can be
adapted to pre-heat your vehi-
cle's passenger compartment.
Reinitialising the remote control
If the vehicle's battery is disconnect-
ed or the remote control's battery is
replaced, the remote control must be
reinitialised.
After switching on the power, press
button
4
(OFF) for 1 second within the
next 5 seconds. If the operation has
taken place correctly the message
"OK"
is displayed on the remote con-
trol screen.
If a problem occurs, the message
"FAIL"
appears. Repeat the operation.
Do not discard the used bat-
teries, take them to an ap-
proved collection point.
Summary of Contents for 407 2010
Page 15: ...1 18 ...
Page 34: ...3 COMFORT 34 ...
Page 155: ...11 11 TECHNICAL DATA 135 DIMENSIONS IN MM 407 saloon 407 SW ...