5
Installation and Operating Instructions for Newbourne 40i Inset Inset Ecodesign Multi Fuel Stove
Ref: Pevex1030/AH/ver1: 1 April 2019
LIGHTING THE STOVE
Note
:
If the fire dies down completely or embers are smoldering then it will be necessary to place some screwed up
paper or firelighters onto the grate with some kindling or small pieces of wood to reestablish the fire once again.
Leave the air slider fully open and allow the fire to build before refueling with larger pieces of wood and then
adjust the air slider for optimum combustion.
Do not overload the firebox by loading above the tertiary air diffuser at the back of the firebox and ensure
that the wood is retained by the log guard. Always ensure that the wood is not tightly stacked so that
air can circulate freely.
Do not leave the door open: Operation with the door open can cause excess smoke. The appliance must
not be operated with the appliance door left open except as directed in the instructions.
Do not leave the airsliders completely open: Operation with the airslider permanently open can cause
excess smoke as well as the stove to burn too hot. The appliance must not be operated with air controls
or dampers left open except as directed in the instructions.
SLUMBERING A STOVE
Whilst it may seem appealing, slumbering a stove at the end of an evening by turning off the air supply is not to
be recommended especially when burning solid fuels. Not only is this harmful to the environment due to the
incomplete combustion of the fuel but there is a potential to create longer term problems to the stove internals
which includes the glass door panel and flue components. Incomplete combustion of the fuel will lead to gas
build up in the fire chamber particularly sulphur, which under certain conditions can start attacking these
components and will not be covered under any circumstance.
3. With the door slightly open the fire will
quickly build warming the stove and
chimney. After about 5/10 minutes the
door can be shut and the stove can be
controlled by the air slider. Adjust the air
lever to about the mid position for optimal
combustion.
1. Put 2 small logs on a bed of ash spaced
about 6-7cm apart. Place some scrunched
up newspaper/paper with 1-2 firelighters in
between and move air lever to right.
2. Neatly stack dry kindling on top of the logs
into approx 3 layers and light the bottom fire
lighters.
5. After about 40/50 minutes and when the
last flames go out a red hot ember bed will
be left and further wood can be added.
6. Place 2/3 logs on the ash bed ensuring
that the wood is not stacked too closely
and with the air slider fully open. The wood
will ignite in 2/3 minutes. Adjust the air
slider for optimum combustion.
3a. Fully open top air slider
3b. And lower air slider and leave
the door slightly ajar to allow air to
enter and the fire to establish.
