- 3 -
Before using your wine cooler
•
Remove the exterior and interior packaging.
•
Before connecting the wine cooler to power source, let it stand upright for approximately 6
hours. This will reduce risk of a malfunction in the cooling system from handling during
transportation.
•
Clean interior surface with lukewarm water by using a soft cloth.
•
When replacing the illuminating lamp, please select a lamp similar to the original. Shut off the
power supply before replacing the lamp.
Installation of your wine cooler
•
Place your wine cooler on a surface strong enough to support it when fully loaded. Level your
wine cooler by adjusting the levelling legs at the bottom front of the wine cooler.
•
Place the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase energy consumption.
•
Extreme cold ambient temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the wine cooler into a properly installed wall outlet. Any questions concerning power
should be directed toward a certified electrician or an authorized products service center.
Pay attention to this
•
Store wine in sealed bottles.
•
Do not overload the wine cooler.
•
Do not open door unless needed.
•
Do not cover shelves with aluminium foil or any other material that may prevent air circulation.
•
Should the wine cooler be stored unused for a longer period of time, it is advised, after a good
cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid
possible formation of condensation, mold or odours.
•
The carbon filter should be cleaned and dried at least once a year.
