21
PROBLEMS WITH YOUR WINE COOLER?
You can solve many common Wine cooler problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you can solve the problem before calling the
Service Centre.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Wine cooler does not operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Wine cooler is not cold enough.
Check the temperature control setting.
External environment may require a higher
setting.
The door is open too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off frequently.
The room temperature is hotter than normal.
A large amount of contents has been added
to the Wine cooler.
The door is open too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
The light button is “OFF”.
Vibrations.
Check to assure that the Wine cooler is
level.
The Wine cooler seems to make too much
noise.
The rattling noise may come from the flow of
the refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in
your Wine cooler.
Contraction and expansion of the inside
walls may cause popping and crackling
noises.
The Wine cooler is not level.
The door will not close properly.
The Wine cooler is not level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves are out of position.
Condensation forms on the door.
Condensation will form on the door due to
high humidity in the area. Install the
appliance with sufficient ventilation in a dry
and/ or air-conditioned room
Water condensation may form on the glass
door.
Condensation will form on the door due to
high humidity in the area. Install the
appliance with sufficient ventilation in a dry
and/ or air-conditioned room
Summary of Contents for PN166D
