Seite 1 von 2
Welding Instruction
Welding fillers to use:
Recommended rod electrode
► BÖHLER FOX 7018 (or similar)
Recommended wire electrode
► BÖHLER EMK 6 TOP (or similar)
General information:
To avoid cracks in the material, a pre-heating of the base material of min. +80 ° C is
recommended.
The welding area at the pewag bluetrack should be dry and clean before welding the
stub.
The welding seam should not be more than 5 mm.
Instruction:
To avoid excessive heating of the base
material please follow the steps below:
If possible, please always work on two
profiles at the same time.
Please weld only ¼ of a pewag
bluetrack stub at the beginning, see
red marking step 1
– 4.
The next step is to weld ¼ of the stub
on the backside, see red marking
step 5
– 8.
