24
EN
pewag levo clamp LC
• The pewag levo clamps LC are only to be
used for the transporting of single plates
and not sheeting packets.
• The load or the pewag levo clamp LC must
not collide with objects or buildings during
the lifting operation.
• Lower the load in such a way that it comes
to rest in a safe and stable position.
• Always open the pewag levo clamp LC
in a way that will not cause the system to
swing to the other side or fall to the ground
to ensure that there is no danger of a
falling lifting device or parts thereof hitting
persons or objects.
• To prevent damage to the device, never
drop the pewag levo clamp LC.
• Emergency switch-off function: Press the
button „Open clamp“ or „Close clamp“
for 0.5 to 1.0 seconds on the pewag levo
remote control. The pewag levo clamp LC
stops immediately. The emergent switch-
off can be also done directly at the pewag
levo clamp LC (Open/Close button). In
this case the emergency switch- off lasts
between 1.5 to 2.0 seconds.
3.2 Battery
IMPORTANT: Please follow all
instructions carefully and take
note of all warnings.
Improper handling of lithium-ion
batteries may cause fire, personal and/or
material damage!
Please note that, if the battery
is shipped, it is classified as a
hazardous goods shipment and
specific conditions will have to
be complied with. Shipment is carried out
at the user‘s own risk.
Please note that
used batteries must not be air-shipped!
•
NEVER try to open or repair the battery
unit or to replace the battery cells!
• Damaged batteries (e.g. batteries with
cracks, broken parts, bent contacts) must
neither be charged nor used!
• The grid separator is ensured by removing
the battery from the battery compartment.
• If the battery shows signs of expansion
or swelling at any time, stop using it
immediately. If this occurs during charging
or discharging, stop the charging/
discharging process and remove the
battery. Continued use, charging or
discharging of a battery that shows signs of
expanding or swelling constitutes a fire risk!
• Always store the battery in a dry place and
at room temperature.
• Always use the original levo charging
station to charge the battery. If the battery
is charged using an incompatible charger,
there is a risk of fire leading to personal
and/or material damage.
• Keep the battery away from high
temperatures, direct sunlight and fire to
prevent explosions.
• If the battery is too hot to touch, it might
be faulty. Leave the battery to cool down
in a cool place and remove all flammable
material from its vicinity. The battery can
no longer be used. Please contact pewag
and/or your supplier.
3.3 Charging station and multi-adapter
The following safety instructions refer both to
the charging station and to the multi-adapter.
• The connector plug must fit in the socket.
The plug must not be modified in any way.
Do not use adapter plugs with earthed
electrical devices.
• Do not use the cable for purposes other
than its designated use, for instance to
carry the charging station or to remove the
plug from the socket. Keep the cable away
from heat, oil and sharp edges.
• Do not use the charging station in the open
air. Always store at room temperature,
protected from moisture and dirt.
